Configure SIP Trunks between UCx Server Rel 6 and Nortel CS1000
Overview
This page provides instructions on how to setup SIP Trunks between a E-Metrotel UCx Server and a Nortel CS1000.
On the Nortel CS1000
Configure the following:
- IP D-Channel [DCH 96]
- SIP Route [R96]
- RLB [RLI 104 E0:R96]
- CDP [DSC 69] → RLI [104]
On the NRS
Configure and Endpoint and a Route:
Endpoint
- Endpoint Name: ucx
- Trust Node: Yes [checkbox]
- Endpoint Authentication enabled: Authentication Off [Dropdown Menu]
- Static endpoint address: 10.0.7.199 [ucx IP address]
- SIP mode: Proxy Mode
- SIP TCP Transport enabled: NO
- SIP UDP Transport enabled: YES
- SIP TLS Transport enabled: NO
Route
- Endpoint Name: ucx
- DN Type: Private Level 0 regional (CDP Steering Code)
- DN prefix: 69 [ucx DN range]
- Route Cost: 1
On the E-MetroTel UCx Server
SIP Trunk to the CS1000 IP Telephony Node
- Navigate to the PBX-> IP Trunk Assistant page
-
Click on the New Account link
- Enter an Account Name: eg. CS1000-Node
- Set the Trunk Provider to UCx
- Enter a Host / IP address using the IP address of the CS1000 IP Tel Node
- Enter a From Domain using the domain of the NRS
- All other fields should be left as defaults
-
- Click Save
SIP Trunk to the CS1000 IP Network Routing Service
- Add another SIP Trunk using New Account button.
- Enter an Account Name: eg. CS1000-NRS
- Set the Trunk Provider to UCx
- Enter a Host / IP address using the IP address of the CS1000 NRS TLAN
- Enter a From Domain using the domain of the NRS
- All other fields should be left as defaults
-
- Click Save
Create a route for CS1000 CDP dialing
- Click on the Outbound Routes page on the PBX tab.
- Enter an Route Name (eg. CS1000)
- Add dial patterns that match the CDP plan of the CS1000 (eg. [2XXX,3XXX,4XXXX,5XXXX,6[1-8]XX,7XXX,8XXX])
- Configure the Trunk Sequence for Matched Routes: Entry 0 using the name of the SIP Trunk account you created for the CS1000 IP Telephony Node (eg. CS1000-Node)