Infinity 5042 Xstim
Introduction
Packing List
- 5042 Expansion module Xstim enabled
- Stand
- Connecting plate with 4 screws
- Power adaptor
- Power cable
- Ethernet cable
- Quick install reference sheet
Installation
STEP ONE: Connect expansion module to Infinity 5010W phone
Use the connecting plate and 4 screws to connect the module to the phone.
STEP TWO: Attach Stand
STEP THREE: Connect to Power
Method One - Using Power cable
Only up to one expansion module can be powered using the power cable.
Method Two - Using Power Adapter
STEP FOUR: Connect to Network
Connect one end of the ethernet cable to the PC port on the Infinity phone and the other end of the ethernet cable to the Uplink Port of the expansion module.
To share the network connection, you can connect a PC to the Downlink Port of the expansion module.
STEP FIVE: Enable PC Port
From a browser, login to the web interface of the Infinity 5010W phone the expansion module is attached to.
Perform the following steps:
- Navigate to the Network - PC Port page.
- Change the PC Port setting to Connect to Expansion Module.
- Click the SaveSet button.
-
The phone will reboot for the changes to take effect.
- After the 5010W phone has completed its bootup, wait two minutes for the expansion module(s) to communicate with the 5010W. If the expansion module needs to update its firmware, the process can take up to 10 minutes to complete. DO NOT UNPLUG any cables nor power cycle any of the devices during this time.
-
From the web interface, navigate to the Home page, confirm the expansion module(s) are listed.
UCX Configuration
Line Keys
Keys on the expansion module are configured the same way as keys on the main phone.
- Login to the UCx Web-based Configuration Utility.
- Navigate to PBX - PBX Configuration - Extensions (Nortel) page.
- Select the desired Nortel extension from the list of extensions located on the top right corner.
- Under Module Type, select 5042 Expansion Module followed by the Number of Modules.
- Under Programmable Keys section, configure the desired keys.
- Press the Submit Changes button.
- Press the Apply Config bar at the top.