XSTIM - Phone User Interface

PREQUISITES

IMPORTANT: The Infinity phone MUST be on the XSTIM firmware version 2.0.4.6.12 or higher.

Accessing Phone Menu

There are two ways to access the phone menu. The default password to use is admin.

Method 1: During Bootup

During the boot up process, when the E-MetroTel logo is displayed, you have 5 seconds to press the 4 softkeys from left to right in sequence. The display will prompt for the password.

Method 2: Conference button

When the phone is idle, long press the Conference  button until the display prompts for the password.

Phone Menu Layout

MAIN MENU SUBMENU Description
Status Information Displays the Phone model, IP address, MAC address, Firmware loads etc.
Server Server Information To configure the UCx server information.
AP Firmware Upgrade To configure the firmware mode and firmware server path.
Network WAN Port To configure WAN port mode, IPv4 and IPv6 settings.
PC Port To configure PC Port as: Bridge, Router or Connect to Expansion Module
Vlan To configure Vlan settings.
Webserver To disable/enable web interface access and type.
802.1x Enable/disable 802.1 mode.
VPN Enable/disable VPN.
DHCP Vlan Enable/disable DHCP Vlan.
LLDP Enable/disable LLDP and settings.
CDP Enable/disable CDP and settings.
Factory Factory Function Tools for factory testing.

Common Usage

Status - Information

This page is typically used to determine the IP address assigned to the phone. Also useful to obtain the MAC address of the phone for configuration in the UCx.

Server - Server Information

Configuring the UCx Server IP address and Port number is a MUST for any XSTIM phone.
This is the first page to enter when configuring an XSTIM phone for the very first time.

AP - Firmware Upgrade

This page is used to configure the firmware and configuration server addresses and also to toggle between SIP and XSTIM firmware mode.

Network - Webserver

By default, the web interface to the phone should be enabled. However if you have trouble accessing the web interface, check this page to ensure the Webserver setting is NOT disabled.

Network - PC Port

By default, the PC port is set to Bridge mode. Using the PC port to connect to the expansion module 5046 is currently not supported.

Factory - Factory Function

Functions on this page are meant for factory testing of the phone.

Function Description
Audio Loopback Test speaker, handset and headset audio, plus color display of the LED lamp.
Diagnostic Mode Test all hardware keys.
Test Keys Test all keys - similar to Diagnostic Mode.
Special Voice Test Test sound quality of the phone.
Lcd Color Test LCD color.