Connect UCx20 Server to the Network

The UCx20 is shipped with a single Network Interface Card (NIC).

The network port on UCx20 by default uses the static IP address 192.168.1.200, with netmask 255.255.255.0 and gateway 192.168.1.1.

If the default network configuration is compatible with your local area network, connect the Ethernet connector of the UCx system to your network with a Cat 5 Ethernet cable, configure your PC's network adaptor to use the 192.168.1.xxx subnet, power up the UCx system and wait approximately 100 seconds for the UCx system to boot.  For connection using Gigabit Ethernet we recommend a Cat 5E or Cat 6 cable!

If the default network configuration is not compatible with your local area network, you may connect the UCx directly to a PC with a statically configured IP address from the 192.168.1.xxx subnet using a Cat 5 Ethernet cable (either straight through or cross over), power up the UCx system and read the information on Network Parameters page on how to change the network configuration.

When the LDD display on the front of the unit displays E-MetroTel and the IP address 192.168.1.200, then the system is ready.