The Firewall Rules page allows you to configure the firewall for your UCX system. When UCX is installed, there is a set of default firewall rules, which are not active.
To activate the Firewall, perform the following steps:
The following diagram shows the default firewall rules for a newly installed R6.0 system. If your system was upgraded from a previous release, the existing rules are retained and the new R6.0 defaults will not be in the list.
To add a new firewall rule, perform the following steps:
To edit a rule, select the corresponding Paintbrush icon in the right column, make desired changes to the rule, and press the Save button to save the changes.
To delete a rule, select the checkbox on the left side of the rule you want to delete, press the Delete button and confirm the action.
Note: After deleting one or more rules, they are removed from the configuration page, but remain active on the system. For the change to take effect, you have to press the Save Changes button to apply the changes to the system.
To change the order of rules, select the Up or Down arrow icon under the Order column. To move a rule up 1 position in the list, select the Up arrow. To move the rule down 1 position in the list select the Down arrow. Changes to the order of rules are immediately applied.