1. Accessing Phone Menu
2. Phone Menu Layout
3. Common Usage
4. Enter Characters from Keypad
There are two ways to access the phone menu.
During the boot up process, when the E-MetroTel logo is displayed, you have 5 seconds to press the 4 softkeys from left to right in sequence. The display will prompt for the password.
When the phone is idle, double press the Conference button to access the phone menu.
MENU | SUBMENU | SubSubMenu | Description |
---|---|---|---|
BASIC - Status | Information | Displays the Phone model, IP address, MAC address, Firmware loads etc. | |
BASIC - Sleep Mode | Sleep Mode | XSTIM - Sleep mode | |
ADVANCED - Server | Server Information | To configure the UCX server information. | |
ADVANCED - AP | Firmware Upgrade | To configure the firmware mode and firmware server path. | |
ADVANCED - Network | WAN Port | IP Port Mode | Select from options: IPv4 | IPv6 | IPv4 & IPv6 |
IPv4 | Set to: DHCP or Static IP Address or PPPoE | ||
IPv6 | Set to: DHCP or Static IP Address | ||
WAN HTTP Access | Enable/disable WAN HTTP access | ||
PC Port | To configure PC Port as: Bridge, Router or Connect to Expansion Module | ||
Vlan | To configure Vlan settings. | ||
Webserver | To disable/enable web interface access and type: HTTP&HTTPS | HTTP Only | HTTPS Only | Off | ||
802.1x | Enable/disable 802.1 mode. | ||
VPN | NOT SUPPORTED | ||
DHCP Vlan | Enable/disable DHCP Vlan. | ||
LLDP | Enable/disable LLDP and settings. | ||
CDP | Enable/disable CDP and settings. | ||
ADVANCED - Factory | Factory Function | XSTIM - Factory Function |
This page is typically used to determine the IP address assigned to the phone. Also useful to obtain the MAC address of the phone for configuration in the UCX.
Configuring the UCX Server IP address and Port number is a MUST for any XSTIM phone.
This is the first page to enter when configuring an XSTIM phone for the very first time.
This page is used to configure the firmware and configuration server addresses and also to toggle between SIP and XSTIM firmware mode.
By default, the phone is configured to obtain its IP address via DHCP.
To change the mode to Static IP Address, perform the following steps:
By default, the web interface to the phone should be enabled. However if you have trouble accessing the web interface, check this page to ensure the Webserver Type is NOT disabled.
By default, the PC port is set to Bridge mode. If using the PC port to connect to the expansion module 5046, then change the PC Port setting to Connect to module.
KEYPAD | CHARACTER |
---|---|
1 | , . ? : ; |
2 | 2 a b c A B C |
3 | 3 d e f D E F |
4 | 4 g h i G H I |
5 | 5 j k l J K L |
6 | 6 m n o M N O |
7 | 7 p q r s P Q R S |
8 | 8 t u v T U V |
9 | 9 w x y z W X Y Z |
* | * / " ! @ $ |
0 | 0 <space> < > ( ) { } [ ] _ - |
# | # ' % & * | |